SootSucker 5 Dust Collector

• Captures particulate, fume, and smoke released from Diesel Particulate Filters (DPF) being cleaned using the FSX TrapBlaster Pneumatic Cleaner.

• Includes automatic online self-cleaning cycle pulses dust out of internal filters to drop into the bottom quick-release bucket while operating.

• Sized to operate up to two FSX Pneumatic DPF Cleaners, one FSX Air Flow Test Bench, and two FSX TrapBurner Thermal Cleaners.

• Offline cleaning cycle to clear filters after fan shuts down.

 

Specifications

CFM:  4250 w/clean filter; 1500 CFM w/dirty filter Filters are cleanable and high efficiency Note: An FSX service cleaner has cleaned over two thousand DPF over 18 months without needing to change or clean the filters! Fan is high efficiency non-overloading Inlet port:  16” ID on top; exhaust port on top left 14" x 28" Dimensions:  76”H x 84”W x 30”D (approx.) Weight:  950 lbs    Electrical:  5 HP motor; 208/220/480 Volt, 3-ph, and 115 Volt, 1-ph, 15 amp Air Requirement:  15 CFM @ 90 PSI

Options (choice):

Short Leg with Dust Bucket (SL) (shown) Dimensions: 76"H x 84"W x 30"D Dust Bucket: 5 gal with quick release Long Leg with Barrel (LL) (not shown) Dimensions: 118"H x 84"W x 30"D Barrel connection (barrel not included)

Accessories:

HEPA Module with Filters (HEPA) Replaces exhaust stack; cabinet has same dimensions; (2) 24" x 24" filters Allows return of air indoors

Ancillary Equipment needed or suggested:

Inlet duct connection to other equipment Exhaust duct for venting outdoors if needed Electrical and air connections